主管单位:中国船舶重工集团公司
主办单位:中国舰船研究院、中国船舶信息中心
地址:北京市朝阳区科荟路55号院
邮编:100101
电话:010-83027274
传真:
E-Mail:
刊号:ISSN ISSN:1672-7649
        CN CN:11-1885/U
国内发行代号:
国际发行代号:
发行范围:国内外公开发布
定价:50元/册
定价:600元/年

您所在位置:首页->过刊浏览->2017年39卷2期



考虑点腐蚀影响的海洋钢结构剩余极限强度研究进展
Review of marine structures residual ultimate strength considering pitting corrosion
王芳1, 张岳林2, 苏里阳3, 赵仕婷4, 白有林4, 胡鹏飞5
点击:1590次 下载:0次
DOI:
作者单位:1. 华中科技大学 自动化学院, 湖北 武汉 430000;
2. 中国人民解放军91404部队, 河北 秦皇岛 066000;
3. 中国人民解放军91550部队, 山东 烟台 265700;
4. 武汉铁路职业技术学院, 湖北 武汉 430033;
5. 海军工程大学, 湖北 武汉 430033
中文关键字:海洋钢结构;极限强度;点腐蚀
英文关键字:marine structures; ultimate strength; pitting corrosion
中文摘要:为得到考虑点腐蚀影响的海洋钢结构剩余强度研究领域的发展趋势,本文对国内外该领域公开发表的文章进行综述,根据本文的研究可以发现:由于海洋钢结构的大尺度和复杂性,数值模拟已成为受蚀船体结构剩余强度的主要研究方法,但模拟结构的有效性仍需进一步检验;对于点腐蚀,就研究参数而言,长细比、DOP、体积损失是学者们最为关注的指标,但对点蚀板强度缺少时变可靠性研究;计算模型中都缺乏对焊接残余应力的考虑。本文所做的研究可为该领域下一步研究方向提供参考。
英文摘要:To get the development trend of marine structures residual ultimate strength considering the influence of corrosion, the paper reviewed articles published in this field at home and abroad, according to the research of this paper:due to the large scale and complexity of marine structures, numerical simulation has become the main research method of the residual strength of corroded marine structures, but the simulation validation still needs further inspection. In terms of corrosion parameters, slenderness ratio, DOP, volume loss were the most attention indexes for researchers, but there is a lack of time-dependent research. The calculation model is lack of considering welding residual stress. The review done in this paper can provide reference for further research in this field.
2017,39(2): 6-11 收稿日期:2016-07-23
DOI:10.3404/j.issn.1672-7619.2017.02.002
分类号:U661.43
作者简介:王芳(1990-),女,硕士研究生,研究方向为机械自动化。
参考文献:
[1] GUEDES SOARES C, Y.G., ZAYED A, et al. Influence of environmental factors on corrosion of ship structures in marine atmosphere[J]. Corrosion Science, 2009, 51:2014-2016.
[2] HUANG Yi, Y., LIU Gang, et al, Ultimate strength assessment of hull structural plate with pitting corrosion damnification under biaxial compression[J]. Ocean Engineering, 2010, 37:1503-1512.
[3] 王燕舞, 崔., 考虑腐蚀影响的船舶结构可靠性研究现状与展望[J]. 船舶力学, 2007, 11(2):307-320.
[4] PAIK J K, A.K.T.. Ultimate limit state design of steel-plated structures, ed. J.W. Sons2003, England.
[5] Rahbar-Ranji, A., Ultimate strength of corroded steel plates with irregular surfaces under in-plane compression[J]. Ocean Engineering, 2012, 54:261-269.
[6] Rahbar-Ranji, A., Plastic collapse load of corroded steel plates. Sadhana, 2012, 37:341-349.
[7] PAIK J.K., J.M.L., M.J. Ko. Ultimate compressive strength of plate elements with pit corrosion wastage in Proceedings of The Institution of Mechanical Engineers[R]. 2003.
[8] D. Ok, Y.P., INCECIK A. Computation of ultimate strength of locally corroded unstiffened plates under uniaxial compression[J]. Marine Structures, 2007, 20:100-114.
[9] D. Ok, Y.P., INCECIK A. Artificial neural networks and their application to assessment of ultimate strength of plates with pitting corrosion[J]. Ocean Eng., 2007, 34:2222-2230.
[10] PAIK J.K., J.M.L., M.J. Ko. Ultimate shear strength of plate elements with pit corrosion wastage[J]. Thin Wall. Struct, 2004, 42:1161-1176.
[11] SAAD-ELDEEN S., Y.G., SOARES C.G. Effect of corrosion severity on the ultimate strength of a steel box girder[J]. Engineering Structures, 2013, 49:560-571.
[12] SADOVSKY Z., C.G.S., TEIXEIRA A.P.. Random field of initial deflections and strength of thin rectangular plates[J]. Reliab. Eng. Syst. Saf., 2007, 92:1659-1670.
[13] SADOVSKY Z., A.P.T., SOARES C.G.. Degradation of the compressive strength of rectangular plates due to initial deflection[J]. Thin Wall. Struct., 2005, 43:65-82.
[14] DUNBAR T.E., N.P., TAHERI F., et al. A computational investigation of the effects of localised corrosion on plates and stiffened panels[J]. Mar. Struct, 2004, 17:385-402.
[15] TAMAGAWA S., Y.K.. Effects of welding residual stress on compressive behaviour and ultimate strength of corroded plate[J]. Int. J. Steel Struct., 2010(10):147-155.
[16] NAKAI T., H.M., YAMAMOTO N.. Effect of pitting corrosion on the ultimate strength of steel plates subjected to in-plane compression and bending[J]. Mar. Sci. Technol, 2006(11):52-64.
[17] 胡勇, 船体结构中船体板摇荡后的平均应力-应变曲线[J]. 上海交通大学学报, 2003, 37:1947-1952.
[18] MATEUS A.F., J.A.W.. On the post-buckling of corroded steel plates used in marine structures[J]. RINA, Trans, 1998, 140:165-183.
[19] XU M., D.Y., FUJIKUBO M., et al. Influence of boundary conditions on the collapse behaviour of stiffened panels under combined loads[J]. Marine Structure, 2013, 34:205-225.
[20] XU M., M.F., SOARES C.G.. Influence of model geometry and boundary conditions on the ultimate strength of stiffened panels under uniaxial compressive loading[J]. Offshore Mech. Arct. Eng, 2013, 135:1-10.
[21] ISSC. Report of specialist committee III.1 ultimate strength[C]//Proceedings of the 16th International Ship and Offshore Structures Congress, 2006, Seoul, Korea.
[22] AHMMAD M., Y.S.. Strength and deformability of corroded steel plates under quasi-static tensile load[J]. J. Mar. Sci. Technology, 2010, 15:1-15.
[23] NAKAI T, M.H., YAMAMOTO N, et al. Effect of pitting corrosion on local strength of hold frames of bulk carriers (1st report)[J]. Marine Structures, 2004, 17:403-432.
[24] ISLAM M.R., Y.S.. Geometrical effects of pitting corrosion on strength and deformability of steel rectangular plates subjected to uniaxial tension and pure bending[J]. J. Jpn. Soc. Naval Architects Ocean Eng, 2011, 14:9-17.
[25] NAKAI T., H.M., YAMAMOTO N.. Effect of pitting corrosion on strength of web plates subjected to patch loading[J]. Thin Wall. Struct, 2006, 44:10-19.
[26] SAAD-ELDEEN S., Y.G., SOARES C.G.. Experimental assessment of the ultimate strength of a box girder subjected to severe corrosion[J]. Mar. Struct, 2011, 24:338-357.
[27] SAAD-ELDEEN S., Y.G., SOARES C.G.. Corrosion-dependent ultimate strength assessment of aged box girders based on experimental results[J]. Ship Res., 2011, 55:289-300.
[28] KHEDMATI M.R., Z.H.M.E.N., ROSHANALI M.M.. A comparative computational investigation on the effects of randomly distributed general corrosion on the post-buckling behaviour of uniaxially loaded plates[J]. Mech. Sci. Technology, 2012, 26:767-783.
[29] SAAD-ELDEEN S., C.G.S.. Effect of pitting corrosion on the collapse strength of rectangular plates under axial compression[R]. Analysis and Design of Marine Structures, ed. P.K.D.E. C. Guedes Soares 2009, London, UK:Taylor & Francis Group.
[30] NAKAI T., H.M., YAMAMOTO N.. Effect of pitting corrosion on local strength of hold frames of bulk carriers (2nd report)-lateral-distortional buckling and local face buckling[J]. Mar. Struct, 2004, 17:612-641.
[31] PAIK J.K., A.K.T.. Ultimate strength of ageing ships[J]. Proc. Instit. Mech. Eng., Part M:J. Eng. Maritime Environ, 2002:57-78.
[32] 王燕舞. 考虑腐蚀影响的船舶结构极限强度研究[D]. 上海:上海交通大学, 2008.
[33] JIANG X., C.G.S.. Ultimate capacity of rectangular plates with partial depth pits under uniaxial loads[J]. Marine Structures, 2012, 26:27-41.
[34] RAHBAR-Ranji, A.. Shear buckling strength of corroded steel plates with irregular surfaces[J]. Zhejiang Univ.-Sci. A (Appl. Phys. Eng.), 2012:1-9.
[35] SILVA M.A.C.E., Y.G., SOARES C.G.. Ultimate strength assessment of rectangular steel plates subjected to a random localised corrosion degradation[J]. Eng. Struct, 2013, 52:295-305.
[36] 冯国庆, 胡冰楠, 吴明远, 等. 随机腐蚀船体板结构极限强度分析. 华中科技大学学报(自然科学版), 2015, 43(12):76-81.
读者评论

      读者ID: 密码:   
我要评论:
国内统一连续出版物号:CN:11-1885/U |国内发行代码: |国际标准出版物号:ISSN:1672-7649 |国际发行代码:
主管单位:中国船舶重工集团公司  主办单位:中国舰船研究院、中国船舶信息中心
版权所有©2019舰船科学技术》编辑部 京ICP备0000000号
本系统由北京菲斯特诺科技有限公司设计开发 技术支持
您是本站第1232421名访问者